Selleys Liquid Nails Heavy Duty 350g

Selleys Liquid Nails Heavy Duty 350g

Selleys Liquid Nails Heavy Duty is an advanced high performance construction adhesive which means mechanical fasteners can be removed after 8 hours*. The non slump formulation also offers extreme strength and durability, even when bonding two non-porous materials. It can be used on most building substrates.

Features
✔2 times more strength than Liquid Nails® in less than half the time
✔*Fast speed of cure means mechanical fasteners can be removed after 8 hours on porous surfaces, compared to 24 hours for Liquid Nails®
✔No drip, slump or stringing, even when applying a bead to overhead surfaces
✔Excellent resistance to water and weather makes it suitable for interior and exterior applications
✔Strong bond that is flexible enough to respond to building movement
✔Easy to extrude from the cartridge at low winter temperatures

Where can this product be used?
Sheet flooring to joists
Metal or aluminium door strips to floors and walls
Timber or fibre cement sheeting to cement block or brick walls
Masonite/hardboard to timber or floorboards
Wallboard or panelling to wood or metal frames
Cork tiles to timber, fibre cement or plaster
Timber flooring to yellow tongue in conjunction with mechanical fixings to avoid later squeaking

What materials is this product suitable for?
Timber
MDF
Plasterboard
Plastics** (pre-test to determine suitability)
Masonry
Concrete
Particleboard
Metals
Rubber
Glass
Tiles
Ceramics
**Not for polyethylene, polypropylene or Teflon.

How to use?
Do not swallow. Use in a well ventilated area. Avoid contact with skin and eyes. Pierce foil seal before inserting into caulking gun.
Ensure surfaces are dry and free from oil, grease and dust. Wipe off any pooled water from wet timber.
Cut cartridge tip and pierce foil, attach nozzle and cut to size (5mm), then insert into caulking gun.
Apply bead along length of joist, stud or batten. On broad flat surfaces apply beads every 40cm.
Position pieces and press firmly together. Fix with sufficient nails, screws or clamping to hold load and achieve contact over total bond area. Repositionable for up to 20 minutes after fitting.
Allow adhesive to set (minimum 8 hours) before removing any temporary fasteners or clamping. Use with mechanical fasteners in high stress applications.

Contact Bond Method:
For immediate bond use contact bond method, apply to one surface only, press together and pull apart. Allow surfaces to dry 2-4 minutes, before firmly joining.

For Flooring:
When fixing sheet flooring (eg. particle board), use in conjunction with flooring manufacturer’s installation specifications for minimum nailing requirements.

Note: To eliminate squeaks in tongue and groove flooring, use Liquid Nails® Heavy Duty in conjunction with mechanical fixings.

Limitations:
Avoid use in tightly clamped joints – eg. cabinet making or joinery.
Not for use on mirrors. Use Liquid Nails® Mirror Aluminium.
Not for metals heated by direct sunlight. Bonds weaken at higher temperatures.
Not for Styrene foam. Use Liquid Nails® Fast Grab.
Do not use as the sole bonding agent for structural bonding.
Not for permanent water immersion.
**Pre-test plastics to determine compatibility. Not for polyethylene, polypropylene or Teflon.